Audio amplifier with bandpass circuit

Audio Amplifier Circuit With RC BandPass

(C) 2017  Bugplan.Com
Home Page - Electronic Circuit Diagrams
Audio amplifier circuit that incorporates a bandpass circuit
A Very Low Noise Single Stage Audio Amplifier that incorporates a simple RC Bandpass filter on its output. When fed into a 10 K Load, its output is shown in the - Output to 10K - block with an RMS output of 1.03 mV.

The filter is designed around the voice standard of 300 to 3000 Hz. Its 3DB cutoff point on the low end is around 320 Hz and the 3DB down cutoff at the high end is around 2.56 DB as shown in the Bode Plot below. In between the two, basically flat.